Liqui Moly Oil Additive MoS2 Engine Flush Plus Petrol and Diesel Service Kit 2591+8374

£19.17
Tax included. Shipping calculated at checkout.

Don't forget these...

Liqui Moly MoS2 Engine Oil Additive 300 ml Made in Germany
Colloidal solid lubricant suspension based on molybdenum disulfide (MoS2) in mineral oil. The product forms a high-load lubricating film on all rubbing and sliding surfaces. This in turn reduces friction, providing for smoother operation of assemblies and greater engine economy. Tested for turbochargers and catalytic converters.
Properties
- reduces oil and fuel consumption
- reduces running-in and operating wear
- no deposits - highest thermal stability
- absolutely compatible with filters
- miscible with all commercially available motor oils
- increases smooth operation
- outstanding emergency-running properties
Areas of application
Added to the lubricating oils of engines, compressors, pumps and especially motor vehicle engines (gasoline and diesel). Mixable with all commercially available motor oils.
Application
Add 5 % (50 ml per liter of oil) of Oil Additive to motor oil; in motorbikes with a wet clutch add 2 % (20 ml per liter of oil). Can be added to motor oil at any time. Shake container before use.
Comment
The maximum dosage for motorcycles with a wet clutch is 2 %!

Liqui Moly Engine Flush Plus 300 ml Made in Germany
With the carrier fluid, the highly effective detergent and dispersant additives dissolve sludge and lacquer formers. All types of oil-soluble and oil insoluble residues are brought into suspension and removed during the next oil change. An engine which has been cleaned of deposits and contamination and which is then filled with fresh oil not contaminated with old impurities can develop its full performance characteristics.
Properties
- optimal engine performance
- highly economical
- tested for turbochargers and catalytic converters
- does not attack common sealing materials
- gentle cleaning
- rapid cleaning
- suitable for diesel particulate filters
- simple to use without disassembly
- minimizes wear
Areas of application
Cleaning and flushing out the oil circuits of gasoline and diesel engines. The use of Engine Flush Plus is dependent on the degree of contamination of the oil circuit. Can be safely used in vehicles with toothed belt running in oil. Not suitable for use on motorbikes with wet clutches.
Application
One 300 ml can is sufficient for up to 6 liters of oil. Add Engine Flush Plus to the motor oil at running temperature before changing the oil. After adding the product, allow the engine to idle for approx. 10 minutes. Then change the oil and the filter. Engine Flush Plus is compatible with all commercially available motor oils.