Liqui Moly Engine Flush + Injector Fuel System Cleaner 1806+8374

Liqui Moly Engine Flush Plus Petrol and Diesel 300ml
with the carrier fluid, the highly effective detergent and dispersant additives dissolve sludge and lacquer formers. All types of oil-soluble and oilinsoluble residues are brought into suspension and removed during the next oil change. An engine which has been cleaned of deposits and contamination and which is then filled with fresh oil not contaminated with old impurities can develop its full performance characteristics.
Properties
- optimal engine performance
- highly economical
- tested for turbochargers and catalytic converters
- does not attack common sealing materials
- gentle cleaning
- rapid cleaning
- suitable for diesel particulate filters
- simple to use without disassembly
- minimizes wear
Areas of application
Cleaning and flushing out the oil circuits of gasoline and diesel engines. The use of Engine Flush Plus is dependent on the degree of contamination of the oil circuit. Can be safely used in vehicles with toothed belt running in oil. Not suitable for use on motorbikes with wet clutches.
Application
One 300 ml can is sufficient for up to 6 liters of oil. Add Engine Flush Plus to the motor oil at running temperature before changing the oil. After adding the product, allow the engine to idle for approx. 10 minutes. Then change the oil and the filter. Engine Flush Plus is compatible with all commercially available motor oils.


Liqui Moly Super Diesel Additive 250ml
A combination of agents which cleans, disperses, protects materials and boosts the cetane number. The lubricity enhancer contained provides sufficient lubricity for diesel fuels low in sulfur. Due to the increased ignition performance, the fuel shows better combustion behavior when the engine is cold and unpleasant odors in the exhaust gases are reduced.
Properties
- keeps the fuel system clean
- for low-sulfur diesel fuels
- keeps injection nozzles clean
- tested for catalytic converters
- prevents seizing and the injector needles from gumming up
- boosts the cetane number
- optimizes engine performance
- increases the lubricating effect
- excellent cleanliness
- prevents the build-up of deposits
- good corrosion protection
- guarantees low fuel consumption
- high wear resistance
Areas of application
Added to diesel fuel for all diesel engines, particularly in modern high pressure diesel engines in passenger cars, trucks, tractors, construction machinery and stationary engines. Ideally suitable for preserving engines when decommissioned for long periods under extreme conditions. Tested for compatibility with turbochargers.
Application
The increase in ignition performance and improvement of the lubricating effect by lubricity enhancers is achieved by adding the product to low-sulfur diesel fuels on a continual basis. One 250 ml can is sufficient for 75 l of diesel fuel. Dosage: 1:300. Clean injectors and corrosion protection by adding to the diesel tank every 2,000 km. 5 l canisters and 50 l drums for trucks, transport companies, bus companies and industry. The dosage rate is in the proportion 1:300 additive to diesel fuel. When decommissioning and preserving engines, add to the diesel fuel at a rate of 1 %. Follow the instructions on preservation. Can be mixed with fuel at any time since mixing takes place automatically.