Liqui Moly Engine Flush Plus + Diesel Engine Purge Cleaning Kit 1811+8374

Liqui Moly Diesel Purge 500ml
Combination of active agents with distinctive cleaning properties. The special additives guarantee corrosion protection and increase ignition performance (cetane number).
Properties
- boosts the cetane number
- increases operational reliability
- eliminates diesel knocking
- reduces deposits
- cleans the fuel system
- good corrosion protection
- guarantees optimum combustion
- highly economical
Areas of application
Used for all diesel engines to prevent and eliminate problems associated with uneven idling and partialload knocking. Quantity to be used for preventive and remedial use: 500 ml is sufficient upto 75 litres of diesel
Application
Preventive use
Add to diesel fuel according to the inspection intervals.
Remedial use
Unclip the fuel pipe and immerse the end in the Diesel Purge. Close the fuel return pipe or feed that into the Diesel Purge. Start the engine and allow the engine to run at different speeds with the Diesel Purge unmixed. After the cleaning process, assemble the vehicle's system. In extreme cases, repeat the cleaning procedure if necessary.

Liqui Moly Engine Flush Plus Petrol and Diesel 300ml
with the carrier fluid, the highly effective detergent and dispersant additives dissolve sludge and lacquer formers. All types of oil-soluble and oilinsoluble residues are brought into suspension and removed during the next oil change. An engine which has been cleaned of deposits and contamination and which is then filled with fresh oil not contaminated with old impurities can develop its full performance characteristics.
Properties
- optimal engine performance
- highly economical
- tested for turbochargers and catalytic converters
- does not attack common sealing materials
- gentle cleaning
- rapid cleaning
- suitable for diesel particulate filters
- simple to use without disassembly
- minimizes wear
Areas of application
Cleaning and flushing out the oil circuits of gasoline and diesel engines. The use of Engine Flush Plus is dependent on the degree of contamination of the oil circuit. Can be safely used in vehicles with toothed belt running in oil. Not suitable for use on motorbikes with wet clutches.
Application
One 300 ml can is sufficient for up to 6 liters of oil. Add Engine Flush Plus to the motor oil at running temperature before changing the oil. After adding the product, allow the engine to idle for approx. 10 minutes. Then change the oil and the filter. Engine Flush Plus is compatible with all commercially available motor oils.